My Community

Posted: **Thu Aug 07, 2008 4:16 pm**

Hi,

I am trying to install VASP to our Mac OSX cluster, using mpich 1.2.5 compiled with xlf90.

It compiles without a problem, but when I run it I get a blank output. No errors, No warnings. Just this:

Code: Select all

==============================================
n99(0):Â Â POSCAR,Â INCARÂ andÂ KPOINTSÂ ok,Â startingÂ setup
n99(0):Â Â WARNING:Â wrapÂ aroundÂ errorsÂ mustÂ beÂ expected
n99(0):Â Â FFT:Â planningÂ ...Â 1
n99(0):Â Â readingÂ WAVECAR
AllÂ nodesÂ terminatedÂ successfully.
=============================================

We don't have the same problem with gamma point only (wNGZhalf). I don't know what else to put here, but please let me know if you need any other information.

Any suggestions?

Thank you very much in advance!

Posted: **Wed Sep 04, 2024 12:11 pm**

Hi,

We're sorry that we didn’t answer your question. This does not live up to the quality of support that we aim to provide. The team has since expanded. If we can still help with your problem, please ask again in a new post, linking to this one, and we will answer as quickly as possible.

Best wishes,

VASP

My Community

Blank output with NGZhalf

Blank output with NGZhalf

Re: Blank output with NGZhalf